Where do I connect that on the controller board?Ī 24V connection to the USB motion card is only needed if you are using limit switches (inputs), powering the spindle/VFD speed and direction, and for the outputs, for powering other devices (mist, coolant, etc.). If you use this method, you'd essentially wire the e-stop as a limit switch.Ĭlick the link to add information to this solution: I recently purchased 3 axis electronics with the USB controller board. Our website datasheet for the USB board is at and shows how to configure the switches for each set up. The wiring would depend on whether and how you might be using limit switches (single or multiple switches normally open or normally closed). Alternatively, you could use an input pin on your USB board. Here is a diagram showing how a customer wired such a switch on their blackTooth laser which you could adapt to your needs. ![]() The simplest, and arguably the most certain, way is to wire the switch into the incoming power so that throwing the switch kills all power to every part of the machine. ![]() There are many ways to wire an emergency stop switch.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |